JUN92d.bs different than JUN92.bs?
Posted: 30 Jan 2019, 17:38
I'm trying to produce some T-X diagrams with domino where X is CO2 using the JUN92d.bs database.
Now there is a helpful powerpoint of this process on the SERC website. However, when I try to replicate this, I get the error "the phase CO2 was not found in the database". I looked in the database and it's there under gas data and it isn't commented out. However, when you type the command "list" after the Domino command it displays several phase names and CO2 is not one of them. In trying to figure out the problem, I noticed that the SERC powerpoints use the JUN92.bs database and not the JUN92d.bs database.
So, the question is, am I making a mistake or cannot you not make T-X co2 diagrams anymore using the JUN92d.bs database? I have a similar problem trying to make binary phase diagrams in Therbin following the instructions in the manual (again, they use the JUN92.bs which apparently has different end members than the ones listed in JUN92d.bs)
Now there is a helpful powerpoint of this process on the SERC website. However, when I try to replicate this, I get the error "the phase CO2 was not found in the database". I looked in the database and it's there under gas data and it isn't commented out. However, when you type the command "list" after the Domino command it displays several phase names and CO2 is not one of them. In trying to figure out the problem, I noticed that the SERC powerpoints use the JUN92.bs database and not the JUN92d.bs database.
So, the question is, am I making a mistake or cannot you not make T-X co2 diagrams anymore using the JUN92d.bs database? I have a similar problem trying to make binary phase diagrams in Therbin following the instructions in the manual (again, they use the JUN92.bs which apparently has different end members than the ones listed in JUN92d.bs)